Ormus Is Not a Bulk Fertilizer

Excellent and very practical question. Moving from the "what" to the "how" is the most important step.

While different producers might have slightly different recommendations based on the concentration of their product, the agricultural Ormus community has established some very consistent and effective best practices.

The single most important principle to remember is: "Less is more."

Ormus is not a bulk fertilizer; it is a trace mineral and energetic supplement. A little goes a very long way. Over-application is wasteful and can, in some cases, be less effective than a properly diluted solution.

Here are the specific, commonly accepted guidelines.

Water Quality: The First Step

Before you mix, know that the quality of your water is crucial.

• Best: Rainwater or distilled water.
• Good: Dechlorinated tap water. (Let tap water sit out in an open container for 24 hours to allow the chlorine to evaporate).
• Avoid: Straight tap water, as the chlorine can negatively interact with the Ormus.

1. Foliar Spraying (Direct Leaf Application)

This is the fastest and most efficient way for the plant to absorb the Ormus.

• Dilution Ratio:

  • Standard Starting Point: 1 tablespoon of Ormus concentrate per 1 gallon of water.
  • For Seedlings/Sensitive Plants: Start with a lower ratio of 1 teaspoon per gallon.
  • Technical Ratio: This equates to roughly a 1:1000 dilution ratio.

• Application Frequency:

  • General Maintenance: Every 1 to 2 weeks during the growing season.
  • For Stressed/Sick Plants: You can increase the frequency to once every 4-5 days for a short period to help with recovery.

• Best Practices for Foliar Spraying:

  • Timing is Key: Spray in the early morning or late evening. Never spray in the direct, hot midday sun, as this can burn the leaves.
  • Cover All Surfaces: Mist the plant until the leaves are thoroughly wet, but not dripping excessively. Pay special attention to spraying the undersides of the leaves, as this is where the majority of the plant's stomata (pores) are located, allowing for maximum absorption.
  • Use a Fine Mist: A fine mist sprayer works best for even coverage.

2. Soil Drenching (Watering the Roots)

This method feeds the root system and enriches the soil's microbiome, providing long-term benefits.

• Dilution Ratio:

  • Standard Starting Point: 1 to 2 tablespoons of Ormus concentrate per 1 gallon of water.
  • Technical Ratio: This is a slightly stronger solution than the foliar spray, around 1:500 to 1:1000.

• Application Frequency:

  • General Maintenance: Use in place of a regular watering every 1 to 2 weeks.
  • When Transplanting: A soil drench right after transplanting can dramatically reduce shock and help the plant establish itself.

• Best Practices for Soil Drenching:

  
  • Apply to Moist Soil: It's best to apply the soil drench when the soil is already slightly moist, not bone-dry. This helps the solution disperse more evenly throughout the root zone.
  • Water Thoroughly: Apply enough of the solution to thoroughly soak the root ball, just as you would with a normal watering.

Quick Reference Summary

Final Advice: The best guide is the plant itself. Start with these standard ratios and observe. The plants will show you if they are happy and thriving. Adjust as you see fit based on their response.